Elegoo Saturn 4 Ultra Slow Mode
Resin is a 50/50 Mix. Anycubic Plant based Resin/Risione TH72. (printed fine yesterday. no crack)
I'm getting a huge Crack thru the base of the Print
any insights or advice is appreciated.
Cracks in Print
-
shadowpunk
- Reactions:
- Posts: 32
- Joined: February 28th, 2022, 6:13 pm
- 3D Printer(s): Mars 3
Cracks in Print
- Attachments
-
-
-
-
-
LePaul
- Reactions:
- Posts: 4059
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cracks in Print
I was watching a review on this printer (VOG I think) saying there's no noticeable difference from Fast or Slow mode.
I'm not an expert but often on these fails I hear about suction force / peeling issues
I'm not an expert but often on these fails I hear about suction force / peeling issues
-
shadowpunk
- Reactions:
- Posts: 32
- Joined: February 28th, 2022, 6:13 pm
- 3D Printer(s): Mars 3
Re: Cracks in Print
i ended up increasing the lift distance a bit.. the next print was flawless.
in the world of 3d printing i'll take that miracle
in the world of 3d printing i'll take that miracle
-
shadowpunk
- Reactions:
- Posts: 32
- Joined: February 28th, 2022, 6:13 pm
- 3D Printer(s): Mars 3
Re: Cracks in Print
so far i've found that speed wise there is a def difference. tho the lift speed is too fast for my supports and they get pulled apart