V1 Engineering's Piper

Topics of Large-Scale 3D Printers
User avatar
Roberts_Clif
Reactions:
Posts: 743
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: V1 Engineering's Piper

Post by Roberts_Clif » June 6th, 2019, 9:38 pm

Today received the Arduino controller the Ramps 1.6 with five A4988 drivers modules.
Decided to upload a known Firmware Marlin 1.1.5 to test the the basics, found that I needed a CH34X driver before it would allow an upload.

Marlin 1.1.5 with the controller an Ramps 1.6 an drivers modules boots, however Marlin for MPCNC is going to need some firmware changes as it is displaying garbage.
Will go over it very carefully to see what i missed.

Ok Missed the Full Graphics Boot Screen, works now.
Electronics Technician / Computer Programmer

User avatar
Roberts_Clif
Reactions:
Posts: 743
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: V1 Engineering's Piper

Post by Roberts_Clif » June 7th, 2019, 7:59 pm

Today I received the five steppers, and setup a Ramps controller test, decided to start with a V-Ref of .450
Setup all steppers an preformed simple moves on X, Y, Z E0 an E1 drivers functioning at my test current..
Electronics Technician / Computer Programmer

Post Reply

Return to “Large Scale 3D Printers”