Page 1 of 1
Cracks in Print
Posted: June 28th, 2024, 3:09 pm
by shadowpunk
Elegoo Saturn 4 Ultra Slow Mode
Resin is a 50/50 Mix. Anycubic Plant based Resin/Risione TH72. (printed fine yesterday. no crack)
I'm getting a huge Crack thru the base of the Print
any insights or advice is appreciated.
Re: Cracks in Print
Posted: June 29th, 2024, 5:34 pm
by LePaul
I was watching a review on this printer (VOG I think) saying there's no noticeable difference from Fast or Slow mode.
I'm not an expert but often on these fails I hear about suction force / peeling issues
Re: Cracks in Print
Posted: June 30th, 2024, 10:59 am
by shadowpunk
i ended up increasing the lift distance a bit.. the next print was flawless.
in the world of 3d printing i'll take that miracle
Re: Cracks in Print
Posted: July 1st, 2024, 11:12 pm
by shadowpunk
LePaul wrote: ↑June 29th, 2024, 5:34 pm
I was watching a review on this printer (VOG I think) saying there's no noticeable difference from Fast or Slow mode.
I'm not an expert but often on these fails I hear about suction force / peeling issues
so far i've found that speed wise there is a def difference. tho the lift speed is too fast for my supports and they get pulled apart