Layer splitting with ABS

Your ABS brand not mentioned in the categories? Chat about it here
Posts: 116
Joined: October 8th, 2017, 10:21 am
Location: Spain
3D Printer(s): FT-5, JGAurora A5S

Re: Layer splitting with ABS

Post by Lez0 » May 31st, 2018, 2:16 am

Found out why part of the print was not very good.
I used Cura with "Use adaptive layers" set with the default settings.
This was used to cut the print time down, but resulted in crappy walls.
I wouldn't be using this setting again.....


Post Reply

Return to “ABS Filament General Discussion”