I wrote a bloat-free STL viewer

Discussion of ANY 3D printing topic you desire!
User avatar
Krishty
Reactions:
Posts: 7
Joined: December 3rd, 2017, 3:31 pm
Location: NRW, Germany
3D Printer(s): DaVinci
Contact:

Re: I wrote a bloat-free STL viewer

Post by Krishty » April 30th, 2018, 12:16 am

LePaul wrote:
April 29th, 2018, 11:12 pm
Did the Thumbnail preview version make it over yet...that's something I would really like. I do like your program, I use yours and the MS one to quickly open and identify what those STLs are
I had too little time to finish the thumbnails, but I PM’d you beta access :)

User avatar
LePaul
Reactions:
Posts: 3134
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: I wrote a bloat-free STL viewer

Post by LePaul » May 2nd, 2018, 11:52 am

Thanks! Just saw that

danilius
Reactions:
Posts: 122
Joined: April 21st, 2016, 5:29 pm
Location: Salford, United Kingdom
3D Printer(s): Ultimaker 2

Re: I wrote a bloat-free STL viewer

Post by danilius » May 13th, 2018, 3:26 am

Just tried this out on a 176mb STL file, it opened in just under a second. For files around the 10mb mark, it looks like the app takes longer to start than it does to display the file, so that's as close to instant as possible. Scrolling through files below the 20bm mark is almost instant. Brilliant! Many thanks.

Post Reply

Return to “General 3D Printing Conversation”

Who is online

Users browsing this forum: No registered users and 1 guest