Squizzle!

Show us your latest print!
Post Reply
User avatar
LePaul
Reactions:
Posts: 3165
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Squizzle!

Post by LePaul » November 21st, 2017, 4:43 pm

Green photographs weird but I love how this came out on the Ultimaker 2+
7C9A7B16-1E29-40CA-A856-B70786FFC349.jpeg
A03D84F0-27D5-4DC6-BC32-6E4D13143164.jpeg

User avatar
jonnybischof
Reactions:
Posts: 310
Joined: February 15th, 2016, 2:48 am
Location: Zurich, Switzerland
3D Printer(s): UMO

Re: Squizzle!

Post by jonnybischof » November 22nd, 2017, 2:33 am

Looks very nice!
I have some lime green filament from Diamond Age - one of the best PLAs I've ever had - printing wise. It just prints that little bit better than others. Maybe the green color particles aren't interfering with printability as much as other particles... My best one is the blue translucent from Diamond Age. That is by far the strongest PLA I've ever had. White is usually the worst from my experience, although the Diamond Age White is pretty good.
Best regards,
Jonny

User avatar
LePaul
Reactions:
Posts: 3165
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: Squizzle!

Post by LePaul » November 22nd, 2017, 9:34 am

I had tried to print the Yoda bust but Cura's supports failed on it mid way through But what did print, at 0.06 layers, was simply amazing.
I figure Yoda would look exceptional in his native green :)

Post Reply

Return to “Show off your latest print”