How to get rid of seams on S3D?

Discussion about Simplify 3D software
User avatar
Posts: 3372
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): UM2+,CR-10S (x2),Tevo Tornado,FT-i3/FT-5/FT-6...

How to get rid of seams on S3D?

Post by LePaul » July 22nd, 2017, 12:58 pm

Well I've searched and tried a lot of settings. Coast at end seems to make it worse, as does the three 'Start..' options for it

Any tips that worked for your prints?

Cura doesn't have this problem. But I find I use S3D more since the BB-8 prints are almost all rounded, so the better supports are needed

Return to “Simplify 3D”