Page 2 of 2
Re: Tweak this?
Posted: March 26th, 2017, 3:22 am
by Neotko
The infill overlap is a bit too high.
What orange spot?
Re: Tweak this?
Posted: March 26th, 2017, 9:09 am
by LePaul
In the previews
Re: Tweak this?
Posted: March 26th, 2017, 11:23 am
by Neotko
The legend says is 'infill' and by the looks it seems infill from layers below. Try to inspect the gcode for that kind of things layer by layer. There's a button to see just current layer selected on the slider.
Re: Tweak this?
Posted: March 26th, 2017, 6:10 pm
by LePaul
Neotko wrote:The infill overlap is a bit too high.
What orange spot?
Do you mean the Outline Overlap, in the Infill tab?
Re: Tweak this?
Posted: March 26th, 2017, 6:31 pm
by Neotko
Yea
Re: Tweak this?
Posted: March 26th, 2017, 6:33 pm
by LePaul
Been reading this...
https://forum.simplify3d.com/viewtopic.php?t=1953
Going to lower to 27% and do a test print That finish could be better
Re: Tweak this?
Posted: March 26th, 2017, 6:38 pm
by Neotko
Indeed. As I said the 3 thinks at the same time...
Also yea 25 is more than ok for almost anything.
Re: Tweak this?
Posted: March 26th, 2017, 8:38 pm
by LePaul
Tried a different small part
Back, with 25%. Right with 20%
Left is Cura default
Re: Tweak this?
Posted: March 28th, 2017, 10:10 am
by LePaul
If you click the photo and zoom in, note the S3D pieces (back and right)....note the sides of the part, especially where the hole mounts are