ColorFabb steelFill
- Izzy
- Reactions:
- Posts: 604
- Joined: February 12th, 2016, 2:29 am
- Location: England
- 3D Printer(s): Ultimaker 2
Re: ColorFabb steelFill
Hi Joel, it looks nice, would like to see it filed etc, I wonder what effect it has on the nozzle? Does it wear like CF. I hope to get a ruby nozzle back and try to get a sample of it.
I also need to think about getting a tumbler to try polishing these type of parts
I also need to think about getting a tumbler to try polishing these type of parts
- Neotko
- Reactions:
- Posts: 1142
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
- Contact:
Re: ColorFabb steelFill
It wears nozzle, the prints weighs a lot (so less filament per roll) and it needs more sanding then bronze/brass to shine, also can be slightly attracted by magnets (so it's a different kind of normal steel).
- LePaul
- Reactions:
- Posts: 3978
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: ColorFabb steelFill
The website (which shows 2 in stock....odd) indicates it causes less wear than the XT-CF20
The low temperature for use was interesting.
I have no use for this particular filament (aluminum would be interesting, tho) but the settings for use seem less problematic than CF20
The low temperature for use was interesting.
I have no use for this particular filament (aluminum would be interesting, tho) but the settings for use seem less problematic than CF20