3D Printing Forum

Hello,

My printer will not print/cure the resin.

I think the issue is either the LCD or the UV power lamp.
Can you tell which is it from watching the attached videos ?
Any pointers would be appreciated.

Many thanks,

R.

Hi
I have an Anycubic Photon.
This is my screen shot taken at an angle. It has a bad area at the front to the left, but still works on smaller prints. I hope this helps.
Lez

To anyone who may read this post in the future the problem was with the LCD.
Managed to replace it and do all the necessary calibrations and it works great now.

Glad you got it sorted.