3D Printing Forum

Printed on a Anycubic Kobra 3
220C nozzle
66C Bed

Gyroid infill at 4%
about a 4 Hour Print without supports with Tree Supports and 15 % infill About 8 hours.

No this was not a Christmas present I just had a whim and bought a couple.

I did give my Nephew my 1st Hictop 3DP11 ("Red").

Though still have Blu and Pur had not named my two Kobras yet though have been referring too them as NB and ST.
This was a designation for location they were placed after purchased by their location on a shelf.

NB (North, Bottom) North is current location Bottom was original shelf location)
ST (South, Top) South is current location Top was original shelf location)