First layers is bad... Why?
Posted: August 2nd, 2024, 10:28 pm
Hello folks!
Just wondering. I have an brand new Elegoo Mars 5 Ultra. I trying to print an box with lid in 45 degree angle. Booth the box and the lid printing fine. No warping etc. they fit perfect together.
BUT... 1/4 of my box getting some strange lines. You can see them on the picture below.
Can someone tell me why this happend?
I use Elegoo ABS Like V2 resin and my curing time is set to 3 sec.
Just wondering. I have an brand new Elegoo Mars 5 Ultra. I trying to print an box with lid in 45 degree angle. Booth the box and the lid printing fine. No warping etc. they fit perfect together.
BUT... 1/4 of my box getting some strange lines. You can see them on the picture below.
I use Elegoo ABS Like V2 resin and my curing time is set to 3 sec.