Page 1 of 1

Distance between supports

Posted: January 7th, 2024, 10:03 pm
by raminee
Hi

Is there a general rule of thumb on the distance between support structures say for Light/medium supports ??


My parts are not heavy or dense ,in fact the opposite. I am dealing with very thin and precise parts and would like to avoid the markings left by the support ends.

I am using Anycubic Photon Mono2
Thx
Raminee

Re: Distance between supports

Posted: January 9th, 2024, 1:45 am
by Lez0
I've just done a batch of very small parts and needed to get a good finish on the support face. All I can say is small supports, and as many as you can put it. As it's small parts if they don't work out you can always print them again. I always print a few extras at the same time just to be sure because sometimes one or 2 don't come out perfect. Another thing, always take off the supports as soon as they come off the printer, they should peal off easily.