Hello all,
I use a Anycubic Kobra 2 Pro printer with Anycubic slicer SW.
There are some issues I would like to fix and don't seem to figure out which parameters to adjust.
The first issue is, that the smoothness of the print is not as perfect as I would like it to be. See first picture. I enabled ironing, which helped, but the result is still not smooth enough.
Ironing parameters: Flow rate: 10 %, Spacing between ironing passes: 0.05 mm.
The second issue is, that the bridge is quite thin, so that the print has openings there. See second picture.
Can someone give me a tip what to adjust?
Thanks in advance.
Smoothness and bridge issues
- LePaul
- Reactions:
- Posts: 3974
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Smoothness and bridge issues
How about to picture of the print?
Ironing is better for flat surfaces, curved, not so much
Ironing is better for flat surfaces, curved, not so much