Anycubic Mega X Irregular Temperature Problem
Posted: March 6th, 2023, 11:54 pm
Good evening,
Hoping someone can help, My Anycubic Mega X recently would fail during all my prints. Working with customer service they thought it was the mother board. Replaced that and it did fix some issues I was having but now my extruder temperature will read -14 degrees and will not heat up at all. I have flashed both the original firmware and then tried Knurtwurst (sp) with no change. I have tried multiple extruders and also replaced the little board in the extruder assembly but no luck. Not sure where to go from here, any ideas?
Hoping someone can help, My Anycubic Mega X recently would fail during all my prints. Working with customer service they thought it was the mother board. Replaced that and it did fix some issues I was having but now my extruder temperature will read -14 degrees and will not heat up at all. I have flashed both the original firmware and then tried Knurtwurst (sp) with no change. I have tried multiple extruders and also replaced the little board in the extruder assembly but no luck. Not sure where to go from here, any ideas?