Page 1 of 1
Rough surfaces
Posted: November 24th, 2022, 1:47 am
by Sid Blick
I'm fairly new to 3d printing and still learning. When I first started I was able to get good prints with smooth walls. Haven't done any printing since early in the year and now my prints all have rough walls and I can't figure out what the problem is. I have a Hic-Top Tenlog D3 Pro, and use Ultimaker Cura for slicing. Any ideas on how to fix this problem?
Re: Rough surfaces
Posted: November 26th, 2022, 7:46 pm
by LePaul
Photos would be very helpful to help you diagnose
Re: Rough surfaces
Posted: November 27th, 2022, 7:29 pm
by Roberts_Clif
Posting photos would greatly help us to determine a start for helping you adjust or repair your 3D Printer.
Owning three Hic-top 3D Printers I know much about maintenance required to keep them running.
Re: Rough surfaces
Posted: December 1st, 2022, 2:12 am
by Sid Blick
Thanks for responding. Sorry I haven't been able to get back on, but I just lost a good friend to a heart attack. I'll get back when I can.