Page 1 of 1
another first layer fail
Posted: November 16th, 2022, 7:45 pm
by jbm
I'm trying to print some vessels, basically a cup to make a silicone mold for concrete reproductions. First layer is being wonky at one side. I tried several variations of the stl and they all did the same thing.
Re: another first layer fail
Posted: November 17th, 2022, 9:18 pm
by LePaul
That's very interestng that one side is flattening out. Check the belts? Something is up in the motion system
Re: another first layer fail
Posted: November 17th, 2022, 10:13 pm
by jbm
Thanks for the help. One of the wheels under the build plate was a little loose. I tightened it up and no more wobbly board. Seems to have fixed the problem.
Re: another first layer fail
Posted: November 19th, 2022, 2:55 pm
by LePaul
Hey glad I could help you out!