How to make the NTC glue on ceramic heater more stable?
How to make the NTC glue on ceramic heater more stable?
We try many glue but after heating, NTC still will fall off, do you have better solution?
-
- Reactions:
- Posts: 506
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): Ultimaker 2
Re: How to make the NTC glue on ceramic heater more stable?
Did you try any high temperature epoxy resins? Most of them are good for temperatures of up to 180*C or 200*C but there are also more specialized variants for temperatures of 200-280*C or even 340*C. The problem might just be to get them in super small quantities if you only need it for one bed.