3D Printing Forum

Hi there,

I have an issue of my printer stops printing halfway through.
My printer is Ender 3 v2 and using Cura .

Tried printing twice and both stopped printing at the exact same position.
Please see the attached images

I was using a biodegradable filament earlier then when I switched back to PLA,
I have lowered my printing temperature to 190.


Any help would be appreciated!

Thanks

Id be curious if you skim through the print preview if there is something going on

Or reslice and try again

Thanks for the advice LePaul!
Hmm Preview looks fine.
Just resliced and about to print again.
Fingers crossed

Okay! Let me know how it goes