Printer won’t print in centre of plate using Cura slicer
Posted: June 8th, 2021, 4:03 pm
My new A20M geeetech printer when using Cura slicer always starts printing at x0. Y0 and only prints one quarter of the model.
If I print the G code of the sample model supplied with the printer it prints perfectly. I have printed a model sliced with Repetier and printing started at the centre of the plate but I didn’t know enough about Repetier to be able to heat the base plate so I wish to continue with Cura if I can overcome the start problem. Any suggestions?
If I print the G code of the sample model supplied with the printer it prints perfectly. I have printed a model sliced with Repetier and printing started at the centre of the plate but I didn’t know enough about Repetier to be able to heat the base plate so I wish to continue with Cura if I can overcome the start problem. Any suggestions?