Thread on plastic parts
Posted: April 30th, 2021, 2:19 am
After 3 attempts I finally 3D printed 2 parts with a 1.5mm pitch that screw together.
I don't have a tap for this size, Ø31.5x1.5mm pitch is non standard.
With a little cleaning up this is the results of the test pieces I printed on a resin printer.
very proud of these.
Lez
I don't have a tap for this size, Ø31.5x1.5mm pitch is non standard.
With a little cleaning up this is the results of the test pieces I printed on a resin printer.
very proud of these.
Lez