Having issues printing this model sliced with Cura. At the level the three holes, there is thinning between the holes.
Can't figure it our after trying different retraction, combing, and Z Hop settings.
Issue with printing, sliced with Cura
- Roberts_Clif
- Reactions:
- Posts: 1387
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Issue with printing, sliced with Cura
This is quite a frequent problem with Cura and happens quite often.
when any change happens on Z-Axis, could be many changes to the shape of the model, the outcome is always the same style texture surface change.
Look at this example
when any change happens on Z-Axis, could be many changes to the shape of the model, the outcome is always the same style texture surface change.
Look at this example
Re: Issue with printing, sliced with Cura
So, is there a resolution for this type of issue? I've been trying for months to resolve it, and nothing seems to work.
- LePaul
- Reactions:
- Posts: 3982
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Issue with printing, sliced with Cura
4.9 Beta just came out....worth a try?
- Roberts_Clif
- Reactions:
- Posts: 1387
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Issue with printing, sliced with Cura
Do not know if this is a solution or not, here goes.
I have printed most recent models with PrusaSlicer 2.3.0 it is more complex to setup though the printed model show results.
I still use Cura for other models that need less perfection.
I have printed most recent models with PrusaSlicer 2.3.0 it is more complex to setup though the printed model show results.
I still use Cura for other models that need less perfection.
Last edited by Roberts_Clif on April 8th, 2021, 8:07 pm, edited 1 time in total.
- LePaul
- Reactions:
- Posts: 3982
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Issue with printing, sliced with Cura
There's also the Cura Users group on Facebook you could ask