looking for help with high temp plastic set up on ender 5

Discussion of ANY 3D printing topic you desire!
Post Reply
Ramp-Ha's Rc's
Reactions:
Posts: 1
Joined: November 13th, 2019, 3:47 pm
3D Printer(s): Ender 3&5

looking for help with high temp plastic set up on ender 5

Post by Ramp-Ha's Rc's » November 13th, 2019, 4:36 pm

Looking for help with high temp plastic set up's.

I have an ender 5 that i'm building into a high temp printer. Currently mod's are, micro swiss all metal mk8 hot end, Ollson ruby .4 nozzle, capricorn bowden tube, direct extrusion, liner rails, enclosure, cr10 dual gear extruder. stock control board. So my question is do i need to change my heater cartridge and thermister as well as firmware changes? If yes to any of they questions please advice on product or direction that may be needed. Thank you all for your time. Bought my first printer in April 2019 an ender 3. so i'm still new at this. It's amazing what you can learn on you tube.

Post Reply

Return to “General 3D Printing Conversation”