Z AXIS CRASHING

Discussion of ANY 3D printing topic you desire!
Post Reply
ray
Reactions:
Posts: 1
Joined: October 25th, 2019, 3:24 pm
3D Printer(s): creality pro

Z AXIS CRASHING

Post by ray » October 25th, 2019, 4:46 pm

hello everyone
just bought this 3d creality pro s printer and for some reason its not working?
maybe someone has ran through this problem and can guide me in the right direction on how to solve this issue :-? ?
so I did all the assembling check to make sure everything is snug up , level the gantry.
so when I turn it on heat the bed up and I am ready to start using the automatic level so once I press the button it does its regular leveling but for some reason when its doing the (Z HEIGHT) it goes up and down and then when it comes down again for the final set height it just keeps going down and ends up CRASHING on the table I then have to turn of the machine OFF.
has anyone had this issue or did I just get a defective machine. :-x :-x :-x :-x :-x :-x

User avatar
Roberts_Clif
Reactions:
Posts: 858
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: Z AXIS CRASHING

Post by Roberts_Clif » October 25th, 2019, 6:58 pm

Wanted to welcome you to the Forum.
Do not have a Creality Pro, will let the forum users that do post the information you need...
Electronics Technician / Computer Programmer

Mr SNG
Reactions:
Posts: 61
Joined: January 1st, 2018, 11:02 am
3D Printer(s): hictop auto leveling desktop 3d printer prusa i3

Re: Z AXIS CRASHING

Post by Mr SNG » October 30th, 2019, 4:27 am

I had this problem when I set up my Hictop printer for the first time. What my issue was, the bed level sensor was adjusted to high.

So if your machine is fitted with sensor on the Z axis that would be the first place I would be looking at. If the sensor is correctly adjusted then It could possibly be an offset value stored in the setup.

Post Reply

Return to “General 3D Printing Conversation”