How to reset HOME where it was before cleaning HotEnd ?

Discussion of ANY 3D printing topic you desire!
Post Reply
ksor
Reactions:
Posts: 19
Joined: June 13th, 2019, 7:40 am
3D Printer(s): CR10s PRO

How to reset HOME where it was before cleaning HotEnd ?

Post by ksor » October 4th, 2019, 11:37 am

I have updated my Firmware to TinyMachines version 1.1.9_B7 TM 3D SSMDN on my CR10s PRO and used it some month with success !
The firmware from Creality was simply usuable ... that's why I updated and it has worked well since - thx to TM !

Now I have disassembled and cleaned the HOT END and put it together again.

Now I want to do levelling again - first with the wheels beneath the bed - I did this 3-4 times so now it's OK !

Then I want to recallibrate the autolevelling 5 X % point table - but the 5. (10. 15. 20. 25.) measuring point is OUTSIDE the bed by 6-8 mm !

In generel there must be a procedure to put the HOME-position where I want it to be - right ?

How come and how do I "move" the 5X5 table inside the bed again ?

ksor
Reactions:
Posts: 19
Joined: June 13th, 2019, 7:40 am
3D Printer(s): CR10s PRO

Re: How to reset HOME where it was before cleaning HotEnd ?

Post by ksor » October 5th, 2019, 11:53 am

Any ideas ?

User avatar
GrueMaster
Reactions:
Posts: 451
Joined: March 15th, 2017, 8:46 pm
Location: Oregon
3D Printer(s): Hictop 3DP-17, Hictop CR-10S

Re: How to reset HOME where it was before cleaning HotEnd ?

Post by GrueMaster » October 5th, 2019, 1:35 pm

It sounds like a misconfigured setting in your marlin configuration.h file. If you can get the source for both firmware versions, I would do a comparison and go from there. It isn't terribly difficult to work with (actually, the Marlin team did a remarkable job at documenting the settings).

Post Reply

Return to “General 3D Printing Conversation”