OctoLapse Plugin for OctoPrint

Wireless/network connectivity to print, control and monitor prints!
Post Reply
User avatar
Roberts_Clif
Reactions:
Posts: 630
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

OctoLapse Plugin for OctoPrint

Post by Roberts_Clif » December 23rd, 2018, 5:35 pm

Today found a new plugin for Octoprint called OctoLapse.
To install simply click on the tool in OctoPrint menu.
Select Plugin Manager
Scroll down to bottom
Click on Get More an search for OctoLapse then install
I choose to watch this video to show me how to configure.
This was a simple to understand video allowing me to setup Octolapse in a matter of minutes.
When I have more time will checkout the options more carefully to see how much versatility Octolapse has.

This allows you to snap a picture at every layer height from the same position. Sweet!!!
As most of you know I have multiply printers, so when i setup the 2nd printer I forgot to turn off time lapse and got dual videos.
Both came out perfectly one 20fps the other was normal Octolapse at one photo per layer. Though they say this is not a good ideal.

Here is a sample video of a 1st video of a simple bed clamp.
Electronics Technician / Computer Programmer

User avatar
LePaul
Reactions:
Posts: 3303
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: OctoLapse Plugin for OctoPrint

Post by LePaul » December 26th, 2018, 1:43 pm

Heard of it and it's pretty neat.

My favorite Octoprint plugin is Octoprint Anywhere :)

User avatar
Roberts_Clif
Reactions:
Posts: 630
Joined: March 25th, 2017, 8:17 am
Location: Washington
3D Printer(s): Hictop 3DP11/12

Re: OctoLapse Plugin for OctoPrint

Post by Roberts_Clif » December 26th, 2018, 8:35 pm

LePaul wrote:
December 26th, 2018, 1:43 pm
Heard of it and it's pretty neat.

My favorite Octoprint plugin is Octoprint Anywhere :)
Have never printed when not close enough to monitor the 3D Printer.

Powered on my Hictop 3DP12 - 24volt 3D Printer the day before Christmas and blew the power supply,
Sparks were flying out threw the 3D Printed Supply cover, as there is a vent hole in the bottom.
Hictop 24V supply case.jpg
Thought would make a video of how to repair a Switching supply.
Did a quick diagnostic to see if it was worth repairing, parts cost grew to more than a replacement supply.
Replaced with the Backup S-480-24 supply had purchased for the 12V 30A 360watt supply on 3DP11.

Supply on order will be here by Dec 31
Electronics Technician / Computer Programmer

Post Reply

Return to “Wireless Printing and Controllers”