Ultimaker Brand PLA
- nilrog
- Reactions:
- Posts: 438
- Joined: February 24th, 2016, 4:48 pm
- Location: Örsundsbro, Sweden
- 3D Printer(s): UMO+
Re: Ultimaker Brand PLA
The printer was purchased one year ago. But the filament bag was not opened until one week ago. So it's been in the airtight bag all the time.
- Izzy
- Reactions:
- Posts: 604
- Joined: February 12th, 2016, 2:29 am
- Location: England
- 3D Printer(s): Ultimaker 2
Re: Ultimaker Brand PLA
You could try heat treating it in the oven, but to be honest just use it as a door stop.
- nilrog
- Reactions:
- Posts: 438
- Joined: February 24th, 2016, 4:48 pm
- Location: Örsundsbro, Sweden
- 3D Printer(s): UMO+
Re: Ultimaker Brand PLA
I don't think it would work well as a doorstop either