Cura 2.3.1 E steps settigns

Discussion of Ultimaker's open-source Cura software
Post Reply
User avatar
antiklesys
Reactions:
Posts: 183
Joined: February 13th, 2016, 8:01 am
3D Printer(s): UMO

Cura 2.3.1 E steps settigns

Post by antiklesys »

Hi,

Does anyone know where to find the E-Steps settings in cura 2.3.1?
It seems it's not in the Machine settings (as in the old cura).
Any clues?
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Cura 2.3.1 E steps settigns

Post by LePaul »

It's a little ironic...new Cura seems to show me too much, causing confusion. Yet I can't find the good old settings (like Start GCODE, etc) in it :)
User avatar
antiklesys
Reactions:
Posts: 183
Joined: February 13th, 2016, 8:01 am
3D Printer(s): UMO

Re: Cura 2.3.1 E steps settigns

Post by antiklesys »

Start gcode and stuff is now in the machine configuration tab
User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Cura 2.3.1 E steps settigns

Post by Neotko »

I think they removed the esteps on all 2.x version. You could just add the esteps gcode order on your start gcode?
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Cura 2.3.1 E steps settigns

Post by LePaul »

antiklesys wrote:Start gcode and stuff is now in the machine configuration tab
Really?

Maybe I have an old version on my work PC I'll go see after installing 2.4 Beta
User avatar
antiklesys
Reactions:
Posts: 183
Joined: February 13th, 2016, 8:01 am
3D Printer(s): UMO

Re: Cura 2.3.1 E steps settigns

Post by antiklesys »

Neotko wrote:I think they removed the esteps on all 2.x version. You could just add the esteps gcode order on your start gcode?
Yes, that's what I did
Post Reply

Return to “Cura”