Hi,
Does anyone know where to find the E-Steps settings in cura 2.3.1?
It seems it's not in the Machine settings (as in the old cura).
Any clues?
Cura 2.3.1 E steps settigns
- antiklesys
- Reactions:
- Posts: 183
- Joined: February 13th, 2016, 8:01 am
- 3D Printer(s): UMO
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura 2.3.1 E steps settigns
It's a little ironic...new Cura seems to show me too much, causing confusion. Yet I can't find the good old settings (like Start GCODE, etc) in it
- antiklesys
- Reactions:
- Posts: 183
- Joined: February 13th, 2016, 8:01 am
- 3D Printer(s): UMO
Re: Cura 2.3.1 E steps settigns
Start gcode and stuff is now in the machine configuration tab
- Neotko
- Reactions:
- Posts: 1142
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
- Contact:
Re: Cura 2.3.1 E steps settigns
I think they removed the esteps on all 2.x version. You could just add the esteps gcode order on your start gcode?
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura 2.3.1 E steps settigns
Really?antiklesys wrote:Start gcode and stuff is now in the machine configuration tab
Maybe I have an old version on my work PC I'll go see after installing 2.4 Beta
- antiklesys
- Reactions:
- Posts: 183
- Joined: February 13th, 2016, 8:01 am
- 3D Printer(s): UMO
Re: Cura 2.3.1 E steps settigns
Yes, that's what I didNeotko wrote:I think they removed the esteps on all 2.x version. You could just add the esteps gcode order on your start gcode?