On the home page, do you think I should move the general section down under, say, "Filaments"?
Maybe less scrolling for the busier posting areas? (Or leave things alone)
Board layout question...
- Amedee
- Reactions:
- Posts: 599
- Joined: February 15th, 2016, 11:10 am
- Location: Brussels, Belgium
- 3D Printer(s): UMO / UMO+
- Contact:
Re: Board layout question...
No opinion -- I only use the 'Unread' page
- Izzy
- Reactions:
- Posts: 604
- Joined: February 12th, 2016, 2:29 am
- Location: England
- 3D Printer(s): Ultimaker 2
Re: Board layout question...
I usually go straight to unread posts, and then glance to see if there's something interesting, but alphabetically would be good
-
- Reactions:
- Posts: 506
- Joined: February 9th, 2016, 9:56 am
- Location: Stuttgart, Germany
- 3D Printer(s): Ultimaker 2
Re: Board layout question...
Same for me - the unread page is my starting point. I would only wish for the forum to kick me back to the unread page after pressing "mark all read"
- drayson
- Reactions:
- Posts: 254
- Joined: February 15th, 2016, 5:04 am
- Location: Graz, Austria
- 3D Printer(s): UMO with mods :-)
Re: Board layout question...
same to me...Amedee wrote:No opinion -- I only use the 'Unread' page
-
- Reactions:
- Posts: 138
- Joined: August 7th, 2016, 10:29 pm
- Location: Netherlands
- 3D Printer(s): Ultimaker 2
Re: Board layout question...
+1Amedee wrote:No opinion -- I only use the 'Unread' page
- nilrog
- Reactions:
- Posts: 438
- Joined: February 24th, 2016, 4:48 pm
- Location: Örsundsbro, Sweden
- 3D Printer(s): UMO+
Re: Board layout question...
Ditto!Amedee wrote:No opinion -- I only use the 'Unread' page
- martin-bienz
- Reactions:
- Posts: 172
- Joined: February 22nd, 2016, 2:42 am
- Location: Switzerland
- 3D Printer(s): Ultimaker Original, prusa i3 mk2
Re: Board layout question...
Youp, same here.Amedee wrote:No opinion -- I only use the 'Unread' page
- ivan.akapulko
- Reactions:
- Posts: 389
- Joined: February 11th, 2016, 11:27 am
- Location: Ust-Kamenogorsk, Kazakhstan
- 3D Printer(s): Ultimaker 2
- Contact:
Re: Board layout question...
Agreed about Unread pages.
- LePaul
- Reactions:
- Posts: 3978
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Board layout question...
Okay....again I will leave things alone! Thanks for your feedback