Simplify Ultimaker Original with Heated bed question

Discussion about Simplify 3D software
Post Reply
User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Simplify Ultimaker Original with Heated bed question

Post by LePaul »

i wanted to try to figure out Simplify 3D (again)

Downloaded the latest installer (3.1.0)

Going through the settings for the Ultimaker 1

Still not a default profile for the Ultimaker with heated bed....annoying...

So in the temp settings I set the PLA temp to 216 I see it uses T0

Now not sure what to set for heated bed?
s3dtemp.JPG
User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Simplify Ultimaker Original with Heated bed question

Post by Neotko »

User avatar
LePaul
Reactions:
Posts: 3966
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Simplify Ultimaker Original with Heated bed question

Post by LePaul »

Or you could have just said T2.....nevermind. I'll stick to Cura. Not worth the attitude replies
User avatar
Neotko
Reactions:
Posts: 1142
Joined: February 7th, 2016, 7:02 pm
Location: Madrid
3D Printer(s): UMO+ x2.5
Contact:

Re: Simplify Ultimaker Original with Heated bed question

Post by Neotko »

Sorry lepaul, I love to help but rewriting all its time. Also, on that post there are some very interesting points that could help you start a umo&bed profile.
Post Reply

Return to “Simplify 3D”