I am look for any information about Anycubic Slicer Next 1.3.2 is an open-source slicing software developed based on Orcaslicer.
It would be great if I could find a Users guide to allow me to read all about the operation of this slicer.
It is not like I can not figure out enough to be able to print or configure it.
Though it would sure be much easier if I have a users guide to the slicer.
A lot of it is simple as I have used other slicers that operate the same.
It has a complete section for painting your model, as to print in color.
It has a somewhat confusing way of adding modifiers.
If in your web searches you see a users guide to help me please post a link here.
Anycubic Slicer Next
- Roberts_Clif
- Reactions:
- Posts: 1433
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Anycubic Slicer Next
Last edited by Roberts_Clif on January 15th, 2025, 7:08 pm, edited 1 time in total.
- LePaul
- Reactions:
- Posts: 4011
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Anycubic Slicer Next
Teaching Tech has some great tutorials....
- Roberts_Clif
- Reactions:
- Posts: 1433
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Anycubic Slicer Next
Today I am 3D Printing with My Kobra 3 an G-Code created from Orca Slicer 2.2.0 Based on PrusaSlicer, and BambuStudio.
I read that this was not possible, that the AnyCubic slicers had special code to operate the Kobra 3 correctly.
Note : I am only printing with a single color, Still It works so let me continue with the next print in color.
It 3D Printed with perfect color sequence no problems, I wonder what their problems with printing the Kobra 3 in color without AnyCubic Slicer or AnyCubic Slicer Next was...
Now I can not send the G-Code directly to the Printer Yet but I will Find a way
I read that this was not possible, that the AnyCubic slicers had special code to operate the Kobra 3 correctly.
Note : I am only printing with a single color, Still It works so let me continue with the next print in color.
It 3D Printed with perfect color sequence no problems, I wonder what their problems with printing the Kobra 3 in color without AnyCubic Slicer or AnyCubic Slicer Next was...
Now I can not send the G-Code directly to the Printer Yet but I will Find a way