NFC scan plug port
-
Neotko
- Reactions:
- Posts: 1142
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
- Contact:
Re: NFC scan plug port
I supposed you did that, isn't that explained on the a4 paper of first steps to do?
-
LePaul
- Reactions:
- Posts: 4015
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: NFC scan plug port
No it is not on the first steps sheet.
-
LePaul
- Reactions:
- Posts: 4015
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: NFC scan plug port
What's interesting is it worked for a while then stopped working. Looks like recalibrating worked
-
Sebastian96
- Reactions:
- Posts: 2
- Joined: October 29th, 2023, 11:09 am
- 3D Printer(s): google
Re: NFC scan plug port
Hi Guys,instaup
I don't own a UM3, but wouldn't fixing that involve removing the cover, adjusting the mainboard slightly, then securing it back in place? Often, these screws might have some play, and if the cover and board shift relative to each other due to the screws, it could lead to this issue.
I don't own a UM3, but wouldn't fixing that involve removing the cover, adjusting the mainboard slightly, then securing it back in place? Often, these screws might have some play, and if the cover and board shift relative to each other due to the screws, it could lead to this issue.
-
LePaul
- Reactions:
- Posts: 4015
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: NFC scan plug port
6 year old post =)
-
mittal
- Reactions:
- Posts: 1
- Joined: January 14th, 2024, 11:59 am
- 3D Printer(s): UltiMaker PVA Removal Station
Re: NFC scan plug port
Hey,sabir48 wrote: ↑December 30th, 2023, 1:58 pmHi,Sebastian96 wrote: ↑December 1st, 2023, 3:40 am Hi Guys,gold whatsapp
I don't own a UM3, but wouldn't fixing that involve removing the cover, adjusting the mainboard slightly, then securing it back in place? Often, these screws might have some play, and if the cover and board shift relative to each other due to the screws, it could lead to this issue.
Not owning a UM3, but addressing this could entail uncovering the device, tweaking the mainboard alignment, and resecuring it.
I think fixing and tweaking the mainboard alignmet is now need a renovation after 6 years...
