Kreateit Kr-10s help needed please!

Printer firmware discussion
Post Reply
NickPhuket
Reactions:
Posts: 1
Joined: May 4th, 2023, 8:49 am
3D Printer(s): Kreateit Kr-10s

Kreateit Kr-10s help needed please!

Post by NickPhuket »

Hello all,
Very new to the 3d printing world, and not a techie, but I am determined to learn.
I have a kreateit kr-10s, I bought it a few years ago, tried to get it to work, failed miserably, then put it away and forgot about it.

Ive now unearthed it, powered it up, I seem to have mislaid the SD card which had the instructions, such as they were ( translated from Chinese I suspect)
My questions to begin are the following:
Does anyone have one of these printers, and if so would they be willing to send me the SD card data?

On a more general topic, is it possible to use other software to control the printer unit? Either by completely replacing the control unit, or the mainboard, or the firmware? And if so does anyone have ideas as to what would be the simplest and most user friendly?

I hope someone out there can help, and thank you all in advance for your help

Nick
User avatar
LePaul
Reactions:
Posts: 3939
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): 24 - Yes I have a problem!
Contact:

Re: Kreateit Kr-10s help needed please!

Post by LePaul »

Is that a clone of the Creality CR-10 ?
Post Reply

Return to “Firmware”