sup guys,
I want to make keychain sized skulls,animal and human heads. Would a standard resin (water/wash) be OK or will i need the extra strength
of an abs like resin? Will the standard withstand a drop to the pavement on a heavy key ring? I'll be selling these.
standard or abs like
-
- Reactions:
- Posts: 401
- Joined: October 8th, 2017, 10:21 am
- Location: Spain
- 3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2
Re: standard or abs like
I would use Elegoo ABS like resin, I use it all the time, or if you want to be 100% sure use Siraya Tech Blu, it's a bit more expensive but very very strong.
Lez
Lez
- LePaul
- Reactions:
- Posts: 3973
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: standard or abs like
That's good to know, I have heard good things about Siraya.
-
- Reactions:
- Posts: 401
- Joined: October 8th, 2017, 10:21 am
- Location: Spain
- 3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2
Re: standard or abs like
I have used the Siraya Blu neat, it doesn't break, and up to 25% and 75% Elegoo ABS like, it almost unbreakable. I mix it as it's expensive to get in Spain.
Lez
Lez
Re: standard or abs like
Thanks fellers I'll check into the Sariya brand..