Hi there,
for calibration I want to print just 1 (red) wall of this cube but I only can see 2 walls in cura with my pfrofile.
It should look like in image 1.png. In image 2.png it is the slice of the profile I attached. The file extension have to changed to .curaprofile.
Have anybody a Idea which parameter in the profile is wrong?
Cura aycubic profile
Cura aycubic profile
- Attachments
-
- MEGA X-PLA-V1.0 calibration cube.zip
- (3.03 KiB) Downloaded 124 times
-
-
-
LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Cura aycubic profile
Well I added the described printer and your profile (both) say they are corrupted.
Better plan would be to attach your Project File (File -> Save Project) This way we can see you settings and the model all in one.
However, based on the second photo, it looks like that's a single wall print. I assume you're trying to dial in your flow rate?
Better plan would be to attach your Project File (File -> Save Project) This way we can see you settings and the model all in one.
However, based on the second photo, it looks like that's a single wall print. I assume you're trying to dial in your flow rate?