This weekend I will be tearing out the dinning room carpet, and replacing it with lament flooring.
Will also be repairing the composition roofing, over the last few winters a few roofing tab have broken off.
And I need to replace the bathroom roof vent as when it was installed it was done as a temporary solution fix.
And as every weekend I still have the normal yard waste to clean up filling two 60 gallon garbage buckets.
I believe the total of this weekends work will fill my five 60 gallon garbage buckets.
This weekends work load will take up most of my relaxing 3D Printer forum pleasure postponing it until Monday morning.
So will return to the forums again on Monday morning June 8th and see if anyone needs any help then...
And as a side note this is my one thousandth post.
Completely off Topic today
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Completely off Topic today
Last edited by Roberts_Clif on June 7th, 2020, 8:58 am, edited 1 time in total.
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Completely off Topic today
Finished the dinning room floor lament flooring.
- LePaul
- Reactions:
- Posts: 3979
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Completely off Topic today
That’s quite the Honey Do List
- Roberts_Clif
- Reactions:
- Posts: 1386
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Completely off Topic today
Actually that was the short list.
-
- Reactions:
- Posts: 5
- Joined: August 7th, 2021, 1:07 pm
- 3D Printer(s): Dremel Idea Builder 3D Printer Model #3D20-01
Re: Completely off Topic today
Yes it is simple need, but no unnecessary!
-
- Reactions:
- Posts: 4
- Joined: July 15th, 2022, 3:52 am
- 3D Printer(s): Anycubic Mega-S