Hallo fellow 3D printing enthusiasts !
Kindly please help with problem described below...
Suddenly, without any reason, my prints started to look terrible.
I do not recall to change anything in my Cura setup. Already have tried different filaments and speeds...
Can you recognize the problem from the attached pictures?
PLEAS HELP!!! Terrible printing results...
-
- Reactions:
- Posts: 401
- Joined: October 8th, 2017, 10:21 am
- Location: Spain
- 3D Printer(s): JGAurora A5S, Anycubic Photon, Saturn 2
Re: PLEAS HELP!!! Terrible printing results...
Hi.
If I have a problem I always check to see if the nozzle is blocked, try changing it to see.
Lez
If I have a problem I always check to see if the nozzle is blocked, try changing it to see.
Lez
Re: PLEAS HELP!!! Terrible printing results...
Hi Lez and thanks ...
The nozzle is clean, I just have put one...
The nozzle is clean, I just have put one...
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: PLEAS HELP!!! Terrible printing results...
Check your esteps then work up to flow settings
https://mattshub.com/blogs/blog/extruder-calibration
https://mattshub.com/blogs/blog/extruder-calibration