Hictop Controller Pinout

Have a problem or question, suggested links/information/FAQ's? Post it here
Post Reply
User avatar
Roberts_Clif
Reactions:
Posts: 1372
Joined: March 25th, 2017, 8:17 am
Location: Washington, State USA
3D Printer(s): Hictop 3DP11/12

Hictop Controller Pinout

Post by Roberts_Clif »

I have a controller from Hictop MPK V1.

I do not have a complete board Connector Pin-out.

Please supply me any information you may have regarding connector labeled with an " H6 ".

MKP_V1.jpg
More information they replaced the FT232RL - FTDI with an ATmega 16U2 High Speed USB controller this is where H6 connects.
Thank You
Post Reply

Return to “General Questions”