It looks like the default is the simple menus....but I can't find where to get EVERYTHING to show, for example the babystepping and so forth
I did make sure M500 was enabled and things like that.
But I sure hate that default short menu!
Marlin 1.1.9 full menus
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Marlin 1.1.9 full menus
Hi LePaul
Not sure exactly what you are requesting.
Though Babystepping is in Configuration.adv.h and will display when enabled.
#define BABYSTEPPING
Not sure exactly what you are requesting.
Though Babystepping is in Configuration.adv.h and will display when enabled.
#define BABYSTEPPING
- LePaul
- Reactions:
- Posts: 3970
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Marlin 1.1.9 full menus
Yes, I found those and got it working!
They had it off by default (FolgerTech) and after much experimenting, found it
They had it off by default (FolgerTech) and after much experimenting, found it
- Roberts_Clif
- Reactions:
- Posts: 1380
- Joined: March 25th, 2017, 8:17 am
- Location: Washington, State USA
- 3D Printer(s): Hictop 3DP11/12
Re: Marlin 1.1.9 full menus
Thought you had though I ran across this Post and wanted to inquire.