Prints don't start after Tinkergnome Firmware Update

Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
Post Reply
reibuehl
Reactions:
Posts: 454
Joined: February 9th, 2016, 9:56 am
Location: Stuttgart, Germany
3D Printer(s): Ultimaker 2

Prints don't start after Tinkergnome Firmware Update

Post by reibuehl » March 26th, 2018, 12:12 pm

I upgraded my UM2 with Dual Extruders today from Tinkergnome firmware version 16.09 to 17.10.1 using the Tinker-MarlinUltimaker2-dual-17.10.1.hex file. Now I have the strange behavior that when I start a print, the printer heats up the buildplate and nozzle and then just sits there at "Heating up... 100%" and doesn't start the print:
2018-03-25 20.28.12.jpg
Did I do something wrong?
Reiner.

reibuehl
Reactions:
Posts: 454
Joined: February 9th, 2016, 9:56 am
Location: Stuttgart, Germany
3D Printer(s): Ultimaker 2

Re: Prints don't start after Tinkergnome Firmware Update

Post by reibuehl » March 29th, 2018, 6:50 am

With the stock firmware that ships with Cura 15.04, the printer prints fine. Strange...
Reiner.

Post Reply

Return to “Ultimaker 2 / Ultimaker 2+ / Extended & Go”

Who is online

Users browsing this forum: No registered users and 5 guests