Anet A8
running on skynet 1.1
.4 nozzle
hatchbox PLA
no auto level sensor
newest version of cura
When this issue started, i printed two 5 hour prints and they printed beautifully. The next day i started a print and the first layer infill is way over extruding. i am using the same cura settings i have been using successfully.
things i tried:
- bed level (tried near and fare from nozzle) i have been using a business card successfully.
- lowered flow rate to %90, made no difference. (i have been using %104 successfully)
- reloaded the skynet 1.1 firmware
- tried multiple models i printed successfully before