Oh, come on...
It's just Robert's feeder latch after about 1.5 years of use. It was not obvious to spot it, so it gave me the due headache.
Oh, come on...
Not my cup of tea at all. I need stronger stuff
That's why - personally - I would never get a resin based printer. If anything (I know, never going to happen because too expensive), I would want a powder-based SLS printer like those used by Shapeways. These prints are really on a different level of strength & detail compared to FFF.LePaul wrote: ↑October 6th, 2017, 11:59 am I'm curious how bad that resin smells. A friend of mine couldn't wait to have a Duplicator 7 and when he opened the first bottle of resin, it made him physically ill. His wife as asthma so he wouldn't allow her to chance an issue by coming to see the printer in his shop. He had to return it, even in a well vented shop, it was too awful a small to endure.
I like the SLA/resin printers but starting to think they below in clean room with masks and gowns