Whose good with CAD? Mount for UM2 printhead
- LePaul
- Reactions:
- Posts: 3973
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Whose good with CAD? Mount for UM2 printhead
Nice! @Meduza I owe you an alcoholic beverage or three!
- LePaul
- Reactions:
- Posts: 3973
- Joined: February 7th, 2016, 10:26 pm
- Location: Bangor, Maine USA
- 3D Printer(s): 24 - Yes I have a problem!
- Contact:
Re: Whose good with CAD? Mount for UM2 printhead
I thought I would give this a go with the XTCF20
Maybe it would come out a bit nicer if I had retractions on? It seems no matter what you do with this material, you wind up with a blob on the nozzle
Maybe it would come out a bit nicer if I had retractions on? It seems no matter what you do with this material, you wind up with a blob on the nozzle