Print came off the bed...and nozzle blob!

Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
Post Reply
User avatar
LePaul
Reactions:
Posts: 3057
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Print came off the bed...and nozzle blob!

Post by LePaul » December 22nd, 2017, 10:56 am

Well, I guess it was my turn. Thankfully not a nozzle leak...the video from the Octoprint shows the print came off the PEI and plowed all the print into the nozzle/block......wish I had a heat gun to clean up the rest.
25593793_10155730265610169_2033454038_n.jpg

Post Reply

Return to “Ultimaker 2 / Ultimaker 2+ / Extended & Go”

Who is online

Users browsing this forum: No registered users and 2 guests