First layer....how's this look?

Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
Post Reply
User avatar
LePaul
Reactions:
Posts: 3123
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

First layer....how's this look?

Post by LePaul » August 30th, 2017, 3:02 pm

Using the old Olsson pre-production ruby FYI
IMG_8444.JPG

User avatar
Titus
Reactions:
Posts: 252
Joined: February 9th, 2016, 10:20 pm
3D Printer(s): Ultimaker Original+HBK

Re: First layer....how's this look?

Post by Titus » August 31st, 2017, 5:47 am

the real question is, how does other side look ;)

User avatar
LePaul
Reactions:
Posts: 3123
Joined: February 7th, 2016, 10:26 pm
Location: Bangor, Maine USA
3D Printer(s): Ultimaker 2+, FT-5, CR-10, CR-10S, Tevo Tornado
Contact:

Re: First layer....how's this look?

Post by LePaul » August 31st, 2017, 8:48 am

Oh I should take a photo of that

Post Reply

Return to “Ultimaker 2 / Ultimaker 2+ / Extended & Go”

Who is online

Users browsing this forum: No registered users and 10 guests