Ultimaker 2 All Metal Hotend

Discussions concerning the Ultimaker 2 / Ultimaker 2+ series of printers, including the Ultimaker 2 Go
eric1565
Reactions:
Posts: 2
Joined: September 5th, 2017, 10:13 pm
3D Printer(s): Anet A8 & custom CoreXY

Re: Ultimaker 2 All Metal Hotend

Post by eric1565 » September 5th, 2017, 10:26 pm

I had a heat creep issue also on my Anet A8. I built a custom water cooled cold end and it fixed the problem 100%. I am printing in my garage and the temps are between 80-100f. I live in houston tx, it gets HOT here. I have a vid on youtube. HEre is the link


I am 100% happy with it so far. I have not had a failed print since I have installed the new water cooled head. I am also thinking about a new design that will be smaller and more compact. It will still work with the E3D V6 hot end. I noticed that the E3D hot end has a larger thread than the chiniese hot ends I bought. I am assuming they are clones of the older E3D hot ends.

Eric

Post Reply

Return to “Ultimaker 2 / Ultimaker 2+ / Extended & Go”

Who is online

Users browsing this forum: No registered users and 6 guests