Page 1 of 1

Temp readings way off? Help!

Posted: March 17th, 2018, 1:39 pm
by Gimball
Hi,
I’m a newbie to the world of the Ultimaker, although have a RepRap 3d printer Ive been using for a while now without issues. My problem is that I cannot get a successsful temp reading on the printhead or the HBK of the UMO that I’ve inherited.
I’ve had to replace the motherboard and it looks like the display screen is also going to need replacing as it’s flashing on/off (unless you can advise me otherwise?)
I have tried all the Thermo options in Ultimaker Builder/Cura and know that this is a great printer; so am asking for some of your guidance and experience please?
I am planning to have a look at Marlin, but what other steps would you advise?

Re: Temp readings way off? Help!

Posted: March 19th, 2018, 1:53 pm
by LePaul
Is this a UMO or UMO + ?
Is the heated bed from Ultimaker?

Re: Temp readings way off? Help!

Posted: March 24th, 2018, 8:42 am
by Gimball
Hi LePaul

It’s an Ultimaker Original with a heat bed kit

Hope this helps?

Gimball

Re: Temp readings way off? Help!

Posted: March 24th, 2018, 11:03 am
by LePaul
Ask Ultimaker.