After assembling the printer with the UM2 print head I think there is an issue with the hotend fan (the one in the back). It doesn't spin continuously...it spins up, stops, spins up etc.
I'm running Amedee's latest FW and I have tried to tweak the fan settings...although I think most of them are for the nozzle fans? Because even adding highest kickstart time and upping the minimum fan pwm makes no apparent change to the behavior of the hotend fan.
So my question now is...should the fan spin continuously? Or is what I see expected behavior?
Hotend fan on UM2 print head
- nilrog
- Reactions:
- Posts: 438
- Joined: February 24th, 2016, 4:48 pm
- Location: Örsundsbro, Sweden
- 3D Printer(s): UMO+
Re: Hotend fan on UM2 print head
And all fans are stock Ultimaker fans.
- Neotko
- Reactions:
- Posts: 1142
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
- Contact:
Re: Hotend fan on UM2 print head
5V hotend fan should be always on if your board is 2.1.1 and if your board is 2.1.4 it should start when the hotend is at 40-50C IF you selected the option on amedee firmware called..
If all fails maybe the transistor of your 5V fan is damaged. There's other pin with 5V constant but I don't remember where... You should check the board pdf for a 5V and a ground pin. I think there are on some of the ext3? Sorry I don't rememberHot-end fan Hardware
If your UMO+ has an Ultiboard 2.1.4 or newer, the hot-end fan is driven by the hot-end temperature.
Check the following option if you have retrofitted a fan on your hot-end.
Auto fan driven by the first hot-end.
- nilrog
- Reactions:
- Posts: 438
- Joined: February 24th, 2016, 4:48 pm
- Location: Örsundsbro, Sweden
- 3D Printer(s): UMO+
Re: Hotend fan on UM2 print head
Got it working thanks to your link with the pics @Neotko...I had just looked at the board edge for an additional fan connector and wired it up the the additional 24V fan connector
Obviously it never occurred to me to look at the middle of the board for the connector...which is a weird place to put it.
Now the "jetfan" starts as soon as the nozzle reaches 40C![Smile :)](./images/smilies/icon_e_smile.gif)
![Embarrassed :oops:](./images/smilies/icon_redface.gif)
Obviously it never occurred to me to look at the middle of the board for the connector...which is a weird place to put it.
Now the "jetfan" starts as soon as the nozzle reaches 40C
![Smile :)](./images/smilies/icon_e_smile.gif)