Beat me by 1min XDMTVDNA wrote:You can also open gcode files with Simplify3D. The view will probably not work with feature types but at least you should be able to see the difference between travel moves and regular moves if you set the coloring to movement speed.
In my experience the interface of S3D is much nicer to work with than repetier host, and gcode.ws runs really slowly in comparison.
Discussion of the Ultimaker Original and Ultimaker Original + (kit and pre-assembled) printers
- Posts: 1139
- Joined: February 7th, 2016, 7:02 pm
- Location: Madrid
- 3D Printer(s): UMO+ x2.5
Who is online
Users browsing this forum: No registered users and 2 guests